Winter Checklist: 10 Things Every Homeowner Should Do Before Winter

October 29, 2017

Winterize Your Pressure Washer or Ice Might Destroy It

 

You should disconnect the hoses from your pressure washer and spray in a pump antifreeze/ lubricant like Pump Saver from Briggs & Stratton. This forces the water out and replaces it with antifreeze and lube. Pump antifreeze/lubrication is available at home centers. 

 

Disconnect Garden Hoses 

A garden hose that's left connected to a spigot will trap water inside the spigot. When that water freezes, it can bust open the spigot, the hose or both. Sometimes the pipe behind the spigot bursts and sprays hundreds of gallons inside the house. This can happen even with a frost-proof spigot and even if the water supply is off. So always disconnect garden hoses before winter arrives.

 

4 Critical Places to Lube Your Car Before Winter

The cold weather is right around the corner, that's the time to get your car ready for winter driving: lube locks, latches, hinges, window channels and weather stripping. Proper lube can prevent binding and freezing and save you the cost of a busted regulator. You can lube your entire vehicle in less than 20 minutes. All you need is dry Teflon spray, spray lithium grease, a rag and glass cleaner.

Start with the window channels. Lower the window glass and shoot dry Teflon spray down the front, rear and top window channels on each door. Soak the channels. Then run the window up and down several times to spread the lube. Finally, raise the window and clean off overspray with glass cleaner.

Then shoot the door and trunk/hatch lock cylinders. Use the spray straw to force the lock 'door' open. Then inject a quick shot of dry Teflon spray into the lock cylinder. Insert your key and rotate the lock to spread the lube.

Next coat all the weather stripping with dry Teflon spray. Then spread it with a cloth. Finish the job by lubing the hood, trunk or tailgate latches with lithium grease. Then spray the door hinges. Operate the latches and doors several times to spread the grease.

 

Switch to Winter Wiper Blades

 Regular blades often become clogged with snow and ice. The rubber covering on winter blades prevents that problem. The entire blade is wrapped in a rubber boot that prevents ice and snow from sticking or packing. They make for much better visibility and safer winter driving.

 

Clean Attic Venting or Invite Ice Dams

Poor attic ventilation can cause ice dams in the winter months, increase cooling costs, create a home for mold and reduce the life of shingles during the dog days of summer.

Over time, the vents located in your soffits and on some gable-end wall vents get clogged with dust and debris and lose their effectiveness. Clean them with a leaf blower or compressed air. You could use a pressure washer, but stick to a couple quick passes because you don't want to saturate the attic insulation with water. Clean the vents every few years, unless you live near a lot of trees with floating seeds, which can clog vents in one season.

 

Winterize Your Sprinkler System

You don't have to pay someone to blow out your sprinkler system. You can do it with your own compressor, but be aware that even the largest home compressor isn't powerful enough to blow out the entire system at once.

If you like number crunching and you have the original irrigation layout showing the gallons per minute (gpm) of each sprinkler head, divide the gpm of each zone by 7.5. That'll give you the cubic feet per minute (cfm) you need to blow it out. Otherwise, rent a 10-cfm compressor and hose from a tool rental center.

Set the compressor air pressure regulator to a maximum of 80 psi for rigid PVC pipe systems, or 50 psi for flexible black polyethylene pipe. Then turn off the water supply and set the system timer to open just one zone. Next, open the manual drain valve at the end of that zone (if equipped). Then, connect the air line to the blow-out port, as shown. Close off both valves on the backflow preventer. Then remove the plug on the blow-out port and screw in a quick-connect hose adapter. Snap on the air hose and connect the other end to the compressor. Now blow out the line. The heads should pop up and spit out water. Disconnect the hose as soon as they run dry. Don't overdo the blow-out—without water cooling the plastic gears, they can melt in less than a minute. Move on to the next zone and allow the heads to cool. Then go back and blow out each zone a second time.

 

Swap Out the Gas in Small Engines or Replace the Carburetor in the Spring

Standard gas at the pump can gum up a carburetor on a small engine in just a few months. I've had to replace a few carburetors for this reason. Now, when I know that it's the last time I'm going to use a tool for the season, I suck out the gas from the tank with a turkey baster and run the engine dry. Then I add a bit of nonoxygenated gas, which has a longer shelf life but is too expensive to burn all year. I also add a splash of fuel stabilizer and run the engine for a while on the good stuff before storing it.

 

Winterize Your Gas Grill

If you're not a winter griller, now's the time to pack away your grill before it's covered with a foot of snow. In addition to giving your grill a thorough cleaning to remove grease and food scraps, take these steps to help prevent any unpleasant surprises when you fire up your grill again next spring.

Shut off the gas at the LP tank, unfasten the burner, slip the gas tubes off the gas lines and lift out the unit. Coat the burners and other metal parts with cooking oil to repel moisture that can build up over the winter and to prevent rust. Then wrap the burner unit in a plastic bag to keep spiders and insects from nesting in the gas tubes during the winter. This is a common problem that can make for balky starts, uneven flames or even a one-alarm fire the next time you light your grill.

 

If you're storing your grill outside during the winter, just keep the propane tank connected (but shut off) and put a protective cover over the entire grill when you're done cleaning it. If you're storing the grill indoors, don't bring the tank inside, even into the garage or a storage shed. A small gas leak can cause a huge explosion if the tank is stored in an enclosed space. Instead, disconnect the tank and store it outside in an upright position away from dryer and furnace vents and children's play areas. Tape a plastic bag over the grill's gas line opening to prevent insects from nesting.

Is Your TV Ready For The Super Bowl?

Please reload

Featured Posts

The Best Handyman in Omaha!

October 21, 2018

1/10
Please reload

Recent Posts

October 26, 2019

Please reload

Archive
Please reload

Search By Tags